Black buffet table – You only need basic things to build a buffet table for your hall or your living room. In a few simple steps and in some of the sources of your local hardware store you can build a buffet table that is 37 inches long, 18 1/2 inches deep, and 34 inches high. Lightly sand the wood pieces with a light paper. Remove the abrasive veil with an adhesive tape. Apply a thin layer of polyurethane to the sides and edges of the wood panels, decors, and table legs. Allow the polyurethane to dry. Twist the cherry and leg plates and add a layer on the other side. Let dry. Continue to apply the polyurethane coating until you get the desired finish.
Place the four legs on a flat surface. Attach the L tabs at the top of each black buffet table leg. Place a stand on one leg and mark the points for the screws. Drill pilot holes in these markers and insert the screws to secure the bracket. And then, measure 16 inches from the top of each leg and place another L bracket just below the top bracket. Drill pilot holes before installing screws. Place one of the cherry wood plates on a flat surface. Attach the L tabs at the top of each leg at each corner of the panel. Fold the buffoon on the head. Tie the remaining cherry wood plate to the four smaller L brackets.
12 Photos Gallery of: Black Buffet Table Design
Place the black buffet table on the back. Apply a strip of wood glue along the front edges of each wooden panel. Place the decorative adorno on the adhesive and attach it with finished nails, which are attached approximately every 6 inches. Roll the table and add the filling on all four sides. Wipe excess wood glue. Add the cherry wood filling to the nail holes and allow to dry.