Big outdoor ceiling fans – If you want to install a ceiling fan but do not know how, this article will take you through the steps. Turn off the power to the light switch or fuse on the service panel. When this is done, only remove light fixtures. This can be tested by turning the wall switches or by means of a circuit the tester on the lamp itself. If there is an existing fixture, remove it and disconnect wires. You will also have to remove the old support toothpick from the electric box and secure the new mounting bracket. Keep wire nuts that hold the existing wires together as they can be recycled. If there is no central light fixture, determine the center of the room, using one of the techniques below. Attach the side of the fan new joint box directly to the nearest crossbar.
Installing big outdoor ceiling fans snap diagonal lines from opposite corners of the room. The lines will cross into the exact center of the room. Use a tape measure to measure the walls and find the halfway points. Install joint box. It would be best to buy the old work (not new construction) style if you do not have access to the ceiling from above. There are two types, one fan rated box is designed to cut an existing crossbar, this style may be easier to install, but requires that you find the bar rather than avoid it. The other type has an adjustable bar that expands to span between two streams, it may be a bit more complicated to install, but provides more mounting options. Both types work equally well.
12 Photos Gallery of: Ideas to Install Big Outdoor Ceiling Fans
After determining where you want to install the big outdoor ceiling fans, consider your ability to power it. See the tips below for some ideas for a power source. Adjust this location as needed. Then a hole in the hand is cut with a sheetrock experienced, just big enough to feel around with your fingers to check for potential obstacles to the box. This small opening will make patching easier if it is an unsuitable position.